There are a few different ways that you can reset your Kenwood double din. One way is to simply hold down the power button for about 10 seconds. This will usually do the trick and reset the device.
If that doesn’t work, then you can try unplugging the unit from its power source for about 30 seconds and then plugging it back in. This should reset the unit. If neither of these methods work, then you may need to consult your owner’s manual for further instructions on how to properly reset your specific model of Kenwood double din.
- Unplug the power cord from the Kenwood double din
- Press and hold the reset button for 5 seconds
- Reconnect the power cord to the Kenwood double din
Credit: www.amazon.com
FAQ
How Do You Reset a Kenwood Double Din Head Unit?
If your Kenwood head unit is acting up or you want to restore it to its factory settings, here’s how to reset it. First, make sure that the head unit is turned off. Then, press and hold the “Reset” button for about 20 seconds.
The “Reset” button is located on the front of the head unit, just below the display. After a few seconds, you should see a message on the display that says “All settings have been reset to their default values.” Press the “Reset” button again to confirm and exit.
That’s all there is to it!
How Do I Reset My Kenwood Touch Screen?
If your Kenwood touch screen is not responding to touch, it may be necessary to reset the device. Here’s how to do it:
1. Power off the Kenwood touch screen by holding down the power button for about 10 seconds.
2. Remove the batteries from the back of the unit, if possible. If you can’t remove the batteries, unplug the device from any power source.
3. Press and hold down the reset button (usually located on the back or underside of the unit) for about 30 seconds.
4. Replace the batteries and/or plug in the power cord, then turn on the device. The touch screen should now be working properly again.
How Do I Reset My Kenwood Dpx500Bt?
If you’re looking to reset your Kenwood dpx500bt, there are a few things you’ll need to do. First, press and hold the “reset” button for about 15 seconds. This will reset the unit back to its factory settings.
Next, you’ll need to enter in your password (if you have one) and then follow the prompts on the screen. Once everything is entered correctly, your unit should be reset and ready to go!
How Do I Reset My Kenwood Transceiver?
If you need to reset your Kenwood transceiver, there are a few different ways that you can do so. First, you can try resetting the unit by pressing and holding down the “reset” button for about 5 seconds. If that doesn’t work, you can also try unplugging the unit from the power source and then plugging it back in.
Finally, if all else fails, you can always consult the owner’s manual for your specific model of Kenwood transceiver in order to find out how to reset it properly.
How to restore or reset your Kenwood Excelon DDX793, DDX593, DDX393
How to Reset Kenwood Touch Screen Radio
When you need to reset your Kenwood touch screen radio, there are a few things that you will need to do. First, you will need to find the reset button on the back of the radio. Once you have found the button, press and hold it for about five seconds.
After you have held the button for five seconds, release it and then press it again for another five seconds. Once you have done this, the radio should be reset and working properly again.
Conclusion
If you’re looking to reset your Kenwood double din, there are a few things you’ll need to do. First, press and hold the reset button for three seconds. Next, unplug the unit from the power source and then plug it back in.
Finally, press and hold the reset button again for three seconds. Once these steps have been completed, your Kenwood double din should be reset and good as new!